The length of a wire of a potentiometer is 100 cm, and the emf of its standard cell is E volt. It is employed to measure the e.m.f of a battery whose internal resistance is 0.5 Ω. If the balance point is obtained at l = 30 cm from the positive end, the e.m.f. of the battery is :
(1)
(2)
(3)
(4) , where i is the current in the potentiometer
विभवमापी के तार की लंबाई 100 cm है, और इसके मानक सेल का विद्युत वाहक बल E वोल्ट है। इसे ऐसी बैटरी के विद्युत वाहक बल को मापने के लिए नियोजित किया जाता है, जिसका आंतरिक प्रतिरोध 0.5 Ω है। यदि संतुलन बिंदु धनात्मक सिरे से l = 30 cm पर प्राप्त होता है, तब बैटरी का विद्युत वाहक बल ज्ञात कीजिए:
(1)
(2)
(3)
(4) , जहाँ i विभवमापी में धारा है
AB is a potentiometer wire of length 100 cm and its resistance is 10 ohms. It is connected in series with a resistance R = 40 ohms and a battery of e.m.f. 2 V and negligible internal resistance. If a source of unknown e.m.f. E is balanced by 40 cm length of the potentiometer wire, the value of E is
(1) 0.8 V
(2) 1.6 V
(3) 0.08 V
(4) 0.16 V
AB, 100 cm लंबाई का एक विभवमापी तार है और इसका प्रतिरोध 10 ओम है। यह प्रतिरोध R = 40 ओम और नगण्य आंतरिक प्रतिरोध की 2V विद्युत वाहक बल की बैटरी के साथ श्रेणीक्रम में जुड़ा हुआ है। यदि अज्ञात विद्युत वाहक बल E का स्रोत विभवमापी तार की 40 cm लंबाई से संतुलित है, E का मान ज्ञात कीजिए:
(1) 0.8 V
(2) 1.6 V
(3) 0.08 V
(4) 0.16 V
Two resistors are connected (a) in series (b) in parallel. The equivalent resistance in the two cases is 9 ohm and 2 ohms respectively. Then the resistances of the component resistors are :
(1) 2 ohm and 7 ohm
(2) 3 ohm and 6 ohm
(3) 3 ohm and 9 ohm
(4) 5 ohm and 4 ohm
दो प्रतिरोधों को (a) श्रेणीक्रम में (b) समांतर क्रम में जोड़ा जाता है। दोनों स्थितयों में समतुल्य प्रतिरोध क्रमशः 9 ओम और 2 ओम है। तब संबद्ध घटक प्रतिरोधकों के प्रतिरोध ज्ञात कीजिए:
(1) 2 ओम और 7 ओम
(2) 3 ओम और 6 ओम
(3) 3 ओम और 9 ओम
(4) 5 ओम और 4 ओम
A cell of internal resistance r is connected to an external resistance R. The current will be maximum in R, if
(1) R = r
(2) R < r
(3) R > r
(4) None of these
r आंतरिक प्रतिरोध का एक सेल एक बाह्य प्रतिरोध R से जुड़ा है। R में धारा अधिकतम होगी, यदि
(1) R = r
(2) R < r
(3) R > r
(4) इनमे से कोई नहीं
Potential difference between the points P and Q in the electric circuit shown is
(1) 4.5 V
(2) 1.2 V
(3) 2.4 V
(4) 2.88 V
दर्शाए गए विद्युत परिपथ में बिंदु P और Q के बीच विभवांतर ज्ञात कीजिए।
(1) 4.5 V
(2) 1.2 V
(3) 2.4 V
(4) 2.88 V
For what value of unknown resistance X, the potential difference between B and D will be zero in the circuit shown in the figure
(1) 4 Ω
(2) 6 Ω
(3) 2 Ω
(4) 5 Ω
अज्ञात प्रतिरोध X के किस मान के लिए दर्शाए गए परिपथ आरेख में बिंदु B और D के बीच विभवांतर शून्य होगा?
(1) 4 Ω
(2) 6 Ω
(3) 2 Ω
(4) 5 Ω
An electric current is passed through a circuit containing two wires of the same material, connected in parallel. If the lengths and radii of the wires are in the ratio of 4/3 and 2/3, then the ratio of the currents passing through the wire will be
(1) 3
(2) 1/3
(3) 8/9
(4) 2
विद्युत धारा एक ऐसे परिपथ से गुजरती है, जिसमें समान पदार्थ के दो तार समांतर क्रम में जुड़े हुए हैं। यदि तारों की लंबाई और त्रिज्या 4/3 और 2/3 के अनुपात में हैं, तब तार से गुजरने वाली धाराओं का अनुपात होगा:
(1) 3
(2) 1/3
(3) 8/9
(4) 2
The equivalent resistance between points A and B in the circuit shown in the figure is
1. 6R
2. 4R
3. 2R
4. R
आरेख में दर्शाए गए परिपथ में, बिंदुओं A और B के मध्य समतुल्य प्रतिरोध कितना है?
1. 6R
2. 4R
3. 2R
4. R
By ammeter, which of the following can be measured
(1) Electric potential
(2) Potential difference
(3) Current
(4) Resistance
ऐमीटर द्वारा, निम्न में से किसको मापा जा सकता है?
(1) विद्युत विभव
(2) विभवांतर
(3) धारा
(4) प्रतिरोध
Constantan wire is used in making standard resistances because of its :
(1) Specific resistance is low
(2) Density is high
(3) Temperature coefficient of resistance is negligible
(4) Melting point is high
किस कारण से मानक प्रतिरोध बनाने में कान्सटेन्टन तार का उपयोग किया जाता है :
(1) विशिष्ट प्रतिरोध कम होता है
(2) घनत्व अधिक होता है।
(3) प्रतिरोध का ताप गुणांक नगण्य होता है।
(4) गलनांक उच्च होता है।