An ideal ammeter (zero resistance) and an ideal voltmeter (infinite resistance) are connected as shown in Fig. 6.47. The ammeter and the voltmeter readings are :
(1) 6.25 A, 3.75 V
(2) 3.00 A, 5V
(3) 3.00 A, 3.75 V
(4) 6.00 A, 6.25 V
एक आदर्श ऐमीटर (शून्य प्रतिरोध) और एक आदर्श वोल्टमीटर (अनंत प्रतिरोध) आरेख 6.47 में दर्शाए गए अनुसार जुड़े है। ऐमीटर और वोल्टमीटर का पाठ्यांक ज्ञात कीजिए।
(1)6.25 A, 3.75 V
(2) 3.00 A, 5V
(3) 3.00 A, 3.75 V
(4) 6.00 A, 6.25 V
If in the given figure, then resistance X will be :
(1) 5 Ω
(2) 10 Ω
(3) 15 Ω
(4) 20 Ω
यदि दिए गए आरेख में, , तब प्रतिरोध X कितना होगा?
(1) 5 Ω
(2) 10 Ω
(3) 15 Ω
(4) 20 Ω
A 100 W bulb designed to operate on 100 V is to be connected across a 500 V source. Find the resistance to be put in series so that bulb consumes 100 W only.
(1) 100
(2) 500
(3) 400
(4) 300
100 V पर संचालित होने के लिए निर्मित 100 W के एक बल्ब को 500 V स्रोत से जोड़ा गया है। श्रेणीक्रम में कितना प्रतिरोध लगाया जाए, कि बल्ब केवल 100 W की खपत करे।
(1) 100
(2) 500
(3) 400
(4) 300
Figure 7.44 shows three similar lamps connected across a power supply. If the lamp fuses, how will the light emitted by change?
(1) no change
(2) brilliance of both decreases and that of increases
(3) brilliance of both increases
(4) brilliance of both decreases
आरेख 7.44 तीन समान लैंपों को दर्शाता है, जो एक विद्युत आपूर्ति से जुड़े हुए है। यदि लैंप फ़्यूज़ हो जाता है, से प्रकाश कैसे उत्सर्जित होगा?
(1) अपरिवर्तित
(2) की चमक घटती है और जबकि की बढ़ती है।
(3) दोनों की चमक बढ़ती है।
(4) दोनों की चमक घटती है।
An electric bulb rated for 500 W at 100 V is used in a circuit having a 200 V supply. The resistance R that must be put in series with the bulb, so that the bulb draws 500 W, is :
(1) 18
(2) 20
(3) 40
(4) 700
100 V पर 500 W के लिए अंकित एक विद्युत बल्ब का उपयोग 200V आपूर्ति वाले परिपथ में किया जाता है। बल्ब के साथ श्रेणीक्रम में कितना प्रतिरोध R जोड़ा जाना चाहिए, कि बल्ब 500 W आरेखित करता है:
(1) 18
(2) 20
(3) 40
(4) 700
In the Wheatstone's bridge shown, P = 2 Ω, Q = 3 Ω, R = 6 Ω and S = 8 Ω. In order to obtain balance, shunt resistance across 'S' must be [SCRA 1998]
(1) 2 Ω
(2) 3 Ω
(3) 6 Ω
(4) 8 Ω
दर्शाए गए व्हीटस्टोन सेतु में, P = 2 Ω, Q = 3 Ω, R = 6 Ω और S = 8 Ω है संतुलन प्राप्त करने के लिए, 'S' में शंट प्रतिरोध कितना होना चाहिए? [SCRA 1998]
(1) 2 Ω
(2) 3 Ω
(3) 6 Ω
(4) 8 Ω
A copper wire has a square cross-section, 2.0 mm on a side. It carries a current of 8 A and the density of free electrons is 8 × 1028 m–3. The drift speed of electrons is equal to
(1) 0.156 × 10–3 m.s–1
(2) 0.156 × 10–2 m.s–1
(3) 3.12 × 10–3 m.s–1
(4) 3.12 × 10–2 m.s–1
एक तांबे के तार का अनुप्रस्थ-काट क्षेत्रफल 2.0mm भुजा का वर्ग है। यह 8A धारा का वहन करता है और मुक्त इलेक्ट्रॉनों का घनत्व 8 × 1028 m–3 है। इलेक्ट्रॉनों का अपवाह वेग किसके बराबर है?
(1) 0.156 × 10–3 m.s–1
(2) 0.156 × 10–2 m.s–1
(3) 3.12 × 10–3 m.s–1
(4) 3.12 × 10–2 m.s–1
What is the current (i) in the circuit as shown in figure
(1) 2 A
(2) 1.2 A
(3) 1 A
(4) 0.5 A
आरेख में दर्शाए गए परिपथ में धारा (i) का मान कितना है?
(1) 2 A
(2) 1.2 A
(3) 1 A
(4) 0.5 A
Express which of the following setups can be used to verify Ohm’s law
(1) | |
(2) | |
(3) | |
(4) |
ओम के नियम को सत्यापित करने के लिए निम्नलिखित में से किस व्यवस्था का उपयोग किया जा सकता है:
(1) | |
(2) | |
(3) | |
(4) |
A potentiometer is an ideal device of measuring potential difference because
(1) It uses a sensitive galvanometer
(2) It does not disturb the potential difference it measures
(3) It is an elaborate arrangement
(4) It has a long wire hence heat developed is quickly radiated
विभवमापी, विभवांतर को मापने का एक आदर्श उपकरण है क्योंकि-
(1) यह सुग्राही धारामापी का उपयोग करता है।
(2) यह मापे गए विभवांतर को प्रभावित नहीं करता है।
(3) यह एक विस्तृत व्यवस्था है।
(4) इसमें लंबा तार होता है, जिससे ऊर्जा जल्दी विकरित होती है।