Masses of 3 wires of same metal are in the ratio 1 : 2 : 3 and their lengths are in the ratio 3 : 2 : 1. The electrical resistances are in ratio
(1) 1 : 4 : 9
(2) 9 : 4 : 1
(3) 1 : 2 : 3
(4) 27 : 6 : 1
एक ही धातु के 3 तारों का द्रव्यमान 1: 2: 3 के अनुपात में है और उनकी लंबाई 3: 2: 1 के अनुपात में है। विद्युत प्रतिरोधों का अनुपात ज्ञात कीजिए-
(1) 1 : 4 : 9
(2) 9 : 4 : 1
(3) 1 : 2 : 3
(4) 27 : 6 : 1
Two resistors of resistance R1 and R2 having R1 > R2 are connected in parallel. For equivalent resistance R, the correct statement is :
(1)
(2)
(3)
(4) R < R1
R1 और R2 प्रतिरोध के दो प्रतिरोधक, जिनमें R1 > R2, समान्तर क्रम में जुड़े हुए हैं। समतुल्य प्रतिरोध R के लिए, सही कथन है:
(1)
(2)
(3)
(4) R < R1
If the ammeter in the given circuit reads 2 A, the resistance R is :
(1) 1 ohm
(2) 2 ohm
(3) 3 ohm
(4) 4 ohm
यदि दिए गए परिपथ में ऐमीटर का पाठ्यांक 2A है, प्रतिरोध R ज्ञात कीजिए:
(1) 1 ओम
(2) 2 ओम
(3) 3 ओम
(4) 4 ओम
The measurement of the voltmeter in the following circuit is :
(1) 2.4 V
(2) 3.4 V
(3) 4.0 V
(4) 6.0 V
निम्नलिखित परपिथ में वोल्टमीटर का पाठ्यांक ज्ञात कीजिए:
(1) 2.4 V
(2) 3.4 V
(3) 4.0 V
(4) 6.0 V
Referring to the figure below, the effective resistance of the network is
(1) 2r
(2) 4r
(3) 10r
(4) 5r/2
निम्नवत् दिए गए आरेख को संदर्भित करते हुए, समायोजन का प्रभावी प्रतिरोध कितना है?
(1) 2r
(2) 4r
(3) 10r
(4) 5r/2
The current in a conductor varies with time t as where I is in ampere and t in seconds. The electric charge flowing through a section of the conductor during t = 2 sec to t = 3 sec is :
(1) 10 C
(2) 24 C
(3) 33 C
(4) 44 C
एक चालक में धारा समय t के साथ I के रूप में परिवर्तित होती है, जहाँ I ऐम्पियर में है और t सेकण्ड में है। t = 2 सेकण्ड से t = 3 सेकण्ड के दौरान चालक के एक भाग में प्रवाहित होने वाली विद्युत धारा की गणना कीजिए:
(1) 10 C
(2) 24 C
(3) 33 C
(4) 44 C
Resistance as shown in figure is negative at
(1) A
(2) B
(3) C
(4) None of these
जैसा कि आरेख में दर्शाया गया है, प्रतिरोध किस बिंदु पर ऋणात्मक है?
(1) A
(2) B
(3) C
(4) इनमें से कोई नहीं
A battery of internal resistance 4Ω is connected to the network of resistances as shown. In order to give the maximum power to the network, the value of R (in Ω) should be :
(1) 4/9
(2) 8/9
(3) 2
(4) 18
4Ω आंतरिक प्रतिरोध की एक बैटरी को प्रतिरोधों के समायोजन से दर्शाए गए अनुसार जोड़ा गया है। समायोजन को अधिकतम शक्ति देने के लिए, R का मान (Ω में) कितना होना चाहिए?
(1) 4/9
(2) 8/9
(3) 2
(4) 18
Two resistances R1 and R2 are made of different materials. The temperature coefficient of the material of R1 is α and of the material of R2 is –β. The resistance of the series combination of R1 and R2 will not change with temperature, if R1/ R2 equals :
(1)
(2)
(3)
(4)
दो प्रतिरोध R1 और R2 विभिन्न पदार्थों से निर्मित हैं। R1 के पदार्थ का ताप गुणांक α है और R2 के पदार्थ का ताप गुणांक –β है। R1 और R2 के श्रेणीक्रम संयोजन का प्रतिरोध परिवर्तित नहीं होगा, यदि R1/ R2 बराबर है:
(1)
(2)
(3)
(4)
In the circuit element given here, if the potential at point B, VB = 0, then the potentials of A and D are given as
(1)
(2)
(3)
(4)
यहां दिए गए परिपथ अवयव में, यदि बिंदु B पर विभव, VB= 0, तब A और D के विभव को किसके द्वारा व्यक्त किया जाएगा?
(1)
(2)
(3)
(4)