The specific resistance of all metals is most affected by :
(1) Temperature
(2) Pressure
(3) Degree of illumination
(4) Applied magnetic field
सभी धातुओं का विशिष्ट प्रतिरोध, किससे सर्वाधिक प्रभावित होता है?
(1) तापमान
(2) दाब
(3) तीव्रता की कोटि
(4) अनुप्रयुक्त चुंबकीय क्षेत्र
A factory is served by a 220 V supply line. In a circuit protected by a fuse marked 10 A, the maximum number of 100 W lamps in parallel that can be turned on is :
(1) 11
(2) 22
(3) 33
(4) 66
एक कारखाने को 220V आपूर्ति लाइन द्वारा सेवित किया जाता है। 10A अंकित एक फ्यूज द्वारा संरक्षित परपिथ में, समांतर क्रम में 100 W लैंपों की वह अधिकतम संख्या ज्ञात कीजिए, जिन्हें चलाया जा सकता है:
(1) 11
(2) 22
(3) 33
(4) 66
In the circuit shown the cells A and B have negligible resistances. For the galvanometer (g) shown no deflection.The value of is
(a)4V (b)2V
(c)12V (d)6V
आरेख में नगण्य प्रतिरोध के दो सेल A और B दर्शाए गए हैं। के लिये धारामापी (g) कोई विक्षेप नहीं दर्शाता है। का मान ज्ञात कीजिए।
(a) 4V (b) 2V
(c) 12V (d) 6V
Resistors of 1, 2, 3 ohm are connected in the form of a triangle. If a 1.5-volt cell of negligible internal resistance is connected across a 3-ohm resistor, the current flowing through this resistance will be :
(1) 0.25 amp
(2) 0.5 amp
(3) 1.0 amp
(4) 1.5 amp
1, 2, 3 ओम के प्रतिरोधकों को एक त्रिभुज के रूप में जोड़ा गया हैं। यदि नगण्य आंतरिक प्रतिरोध वाला 1.5-वोल्ट का सेल 3-ओम प्रतिरोध से जोड़ा गया है, तब इस प्रतिरोध से प्रवाहित होने वाली धारा कितनी होगी?
(1) 0.25 ऐम्पियर
(2) 0.5 ऐम्पियर
(3) 1.0 ऐम्पियर
(4) 1.5 ऐम्पियर
If you are provided three resistances 2 Ω, 3 Ω and 6 Ω. How will you connect them so as to obtain the equivalent resistance of 4 Ω
(1)
(2)
(3)
(4) None of these
यदि आपको तीन प्रतिरोध 2 Ω, 3 Ω और 6 Ω दिए जाए। तब, 4 Ω समतुल्य प्रतिरोध प्राप्त करने के लिए आप इनको किस प्रकार संयोजित करेंगें?
(1)
(2)
(3)
(4) इनमें से कोई नहीं
In the figure, the value of resistors to be connected between C and D so that the resistance of the entire circuit between A and B does not change with the number of elementary sets used is
(1) R
(2)
(3) 3 R
(4)
आकृति में, C और D के मध्य जोड़े गए प्रतिरोधों का मान कितना होना चाहिए कि A और B के मध्य पूर्ण परिपथ का प्रतिरोध उपयोग किए जाने वाले प्राथमिक युग्मों की संख्या के साथ परिवर्तित न हो-
(1) R
(2)
(3) 3 R
(4)
In order to quadruple the resistance of a uniform wire, a part of its length was uniformly stretched till the final length of the entire wire was 1.5 times the original length, the part of the wire was fraction equal to
(1) 1 / 8
(2) 1 / 6
(3) 1 / 10
(4) 1 / 4
एकसमान तार के प्रतिरोध को चार गुना करने के लिए, इसकी लंबाई के एक हिस्से को एकसमान रूप से तब-तक खींचा गया जब तक पूरे तार की अंतिम लंबाई मूल लंबाई की 1.5 गुना हो गई, तार का हिस्सा किसके बराबर था-
(1) 1 / 8
(2) 1 / 6
(3) 1 / 10
(4) 1 / 4
In the network shown in the figure, each of the resistance is equal to 2 Ω. The resistance between the points A and B is
(1) 1 Ω
(2) 4 Ω
(3) 3 Ω
(4) 2 Ω
आकृति में दर्शाए गए समायोजन में, प्रत्येक प्रतिरोध 2Ω के बराबर है। बिंदु A और B के मध्य प्रतिरोध की गणना कीजिए-
(1) 1 Ω
(2) 4 Ω
(3) 3 Ω
(4) 2 Ω
A battery has e.m.f. 4V and internal resistance r. When this battery is connected to an external resistance of 2 ohms, a current of 1 amp. flows in the circuit. How much current will flow if the terminals of the battery are connected directly
1. 1 Amp
2. 2 Amp
3. 4 Amp
4. Infinite
एक बैटरी का विद्युत वाहक बल 4V और आंतरिक प्रतिरोध r है। जब यह बैटरी 2 ओम के बाह्य प्रतिरोध से जोड़ी जाती है, तब परिपथ में 1 amp धारा प्रवाहित होती है। यदि बैटरी के सिरे सीधे जुड़े हैं, तो कितनी धारा प्रवाहित होगी!
1. 1 Amp
2. 2 Amp
3. 4 Amp
4. अनंत
Two electric bulbs A and B are rated 60 W and 100 W, respectively. If they are connected in parallel to the same source, then,
(1) both the bulbs draw the same current
(2) bulb A draws more current than bulb B
(3) bulb B draws more current than bulb A
(4) currents drawn in the bulbs are in the ratio of their resistances
दो विद्युत बल्ब A और B को क्रमशः 60W और 100W पर अंकित किया गया हैं। यदि इन्हें समान स्रोत से समांतर क्रम में जुड़े हैं, तो,
(1) दोनों बल्ब समान धारा आरेखित करते हैं।
(2) बल्ब A, बल्ब B की तुलना में अधिक धारा आरेखित करता है।
(3) बल्ब B, बल्ब A की तुलना में अधिक धारा आरेखित करता है।
(4) बल्बों में आरेखित धाराएँ इनके प्रतिरोधों के अनुपात में हैं।