A thermally insulated rigid container contains an ideal gas heated by a filament of resistance 100 Ω through a current of 1A for 5 min . Then change in internal energy is -

(1) 0 kJ

(2) 10 kJ

(3) 20 kJ

(4) 30 kJ

A reversible engine converts one-sixth of the heat input into work. When the temperature of the sink is reduced by \(62^{\circ}\mathrm{C}\), the efficiency of the engine is doubled. The temperatures of the source and sink are: 
1. \(80^{\circ}\mathrm{C}, 37^{\circ}\mathrm{C}\)
2. \(95^{\circ}\mathrm{C}, 28^{\circ}\mathrm{C}\)
3. \(90^{\circ}\mathrm{C}, 37^{\circ}\mathrm{C}\)
4. \(99^{\circ}\mathrm{C}, 37^{\circ}\mathrm{C}\)

The P-V diagram shows seven curved paths (connected by vertical paths) that can be followed by a gas. Which two of them should be parts of a closed cycle if the net work done by the gas is to be at its maximum value ?

(1) ac

(2) cg

(3) af

(4) cd

An ideal gas of mass m in a state A goes to another state B via three different processes as shown in figure. If Q₁, Q₂ and Q₃ denote the heat absorbed by the gas along the three paths, then -

(1) Q₁ < Q₂ < Q₃

(2) Q₁ < Q₂ = Q₃

(3) Q₁ = Q₂ > Q₃

(4) Q₁ > Q₂ > Q₃

A thermodynamic process is shown in the figure. The pressures and volumes corresponding to some points in the figure are : $P_A=3\times {10}^{4}Pa,P_B=8\times {10}^{4}Pa$ and $V_A=2\times {10}^{-3}{m}^3,V_D=5\times {10}^{-3}{m}^3$. In process AB, 600 J of heat is added to the system and in process BC, 200 J of heat is added to the system. The change in internal energy of the system in process AC would be 

(1) 560 J

(2) 800 J

(3) 600 J

(4) 640 J

P-V plots for two gases during adiabatic process are shown in the figure. Plots 1 and 2 should correspond respectively to -

(1) He and O₂

(2) O₂ and He

(3) He and Ar

(4) O₂ and N₂

A cyclic process ABCD is shown in the P-V diagram. Which of the following P-T curves represent the same process ?

(1)

(2)

(3)

(4)

A cyclic process ABCA is shown in the V-T diagram. Process on the P-V diagram is -

(1)

(2)

(3)

(4)

Heat energy absorbed by a system in going through a cyclic process shown in figure is 

(1) 10⁷ π J

(2) 10⁴ π J

(3) 10²π J

(4) 10^–3π J

A thermodynamic system is taken from state A to B along ACB and is brought back to A along BDA as shown in the PV diagram. The net work done during the complete cycle is given by the area

(1) P₁ACBP₂P₁

(2) ACBB'A'A

(3) ACBDA

(4) ADBB'A'A