The given electrical network is equivalent to:
1. | \(\text{OR}\) gate | 2. | \(\text{NOR}\) gate |
3. | \(\text{NOT}\) gate | 4. | \(\text{AND}\) gate |
To get output \(Y=1\) for the following circuit, the correct choice for the input is:
1. | \(A=1,~ B= 0, ~C=0\) |
2. | \(A=1,~ B= 1, ~C=0\) |
3. | \(A=1,~ B= 0, ~C=1\) |
4. | \(A=0,~ B= 1, ~C=0\) |
The figure shows a logic circuit with two inputs \(A\) and \(B\) and the output \(C\). The voltage waveforms across \(A\), \(B\), and \(C\) are as given. The logic circuit gate is:
1. \(\text{OR}\) gate
2. \(\text{NOR}\) gate
3. \(\text{AND}\) gate
4. \(\text{NAND}\) gate
The circuit is equivalent to:
1. AND gate
2. NAND gate
3. NOR gate
4. OR gate
In the following circuit, the output \(Y\) for all possible inputs \(A\) and \(B\) is expressed by the truth table:
1. | A | B | Y | 2. | A | B | Y |
0 | 0 | 0 | 0 | 0 | 1 | ||
0 | 1 | 0 | 0 | 1 | 1 | ||
1 | 0 | 0 | 1 | 0 | 1 | ||
1 | 1 | 1 | 1 | 1 | 0 | ||
3. | 0 | 0 | 1 | 4. | 0 | 0 | 0 |
0 | 1 | 0 | 0 | 1 | 1 | ||
1 | 0 | 0 | 1 | 0 | 1 | ||
1 | 1 | 1 | 1 | 1 | 1 |
Zener breakdown will occur if:
1. impurity level is low.
2. impurity level is high.
3. impurity is less on the \(\mathrm{n\text-}\)side.
4. impurity is less on the \(\mathrm{p\text-}\)side.
The logic behind the 'NOR' gate is that it gives:
1. | High output when both the inputs are low. |
2. | Low output when both the inputs are low. |
3. | High output when both the inputs are high. |
4. | None of these |
A \(2\) V battery is connected across the points \(A\) and \(B\) as shown in the figure given below. Assuming that the resistance of each diode is zero in forward bias and infinity in reverse bias, the current supplied by the battery when its positive terminal is connected to \(A\) is:
1. | \(0.2\) A | 2. | \(0.4\) A |
3. | zero | 4. | \(0.1\) A |
In the circuit given below, if \(V(t)\) is the sinusoidal voltage source, then the voltage drop \(V_{AB}(t)\) across the resistance \(R\):
1. | is half-wave rectified. |
2. | is full-wave rectified. |
3. | has the same peak value in the positive and negative half-cycles. |
4. | has different peak values during the positive and negative half-cycles. |