The adjacent graph shows the extension $\left(∆l\right)$ of a wire of length 1m suspended from the top of a roof at one end with a load W connected to the other end. If the cross sectional area of the wire is ${10}^{-6}{m}^2$ calculate the young’s modulus of the material of the wire

1. $2\times {10}^{11}N/m^2$

2. $2\times {10}^{-11}N/m^2$

3. $3\times {10}^{-12}N/m^2$

4. $2\times {10}^{-13}N/m^2$

The diagram shows stress v/s strain curve for the materials A and B. From the curves we infer that

1. A is brittle but B is ductile  

2. A is ductile and B is brittle

3. Both A and B are ductile      

4. Both A and B are brittle

If the potential energy of a spring is V on stretching it by 2 cm, then its potential energy when it is stretched by 10 cm will be

1. V/25                                   

2. 5V

3. V/5                                    

4. 25V

Two wires of the same diameter of the same material having the length \(l\) and \(2l.\) If the force \(F\) is applied on each, the ratio of the work done in the two wires will be:
1. \(1 : 2       \)
2. \(1 : 4\)
3. \(2 : 1           \)
4. \(1 : 1\)

A \(5~\text{m}\) long wire is fixed to the ceiling. A weight of \(10~\text{kg}\) is hung at the lower end and is \(1~\text{m}\) above the floor. The wire was elongated by \(1~\text{mm}.\) The energy stored in the wire due to stretching is:
1. zero                        
2. \(0.05~\text J\) 
3. \(100~\text J\)                          
4. \(500~\text J\)

If the force constant of a wire is \(K\), the work done in increasing the length of the wire by \(l\) is:
1. \(\frac{Kl}{2}\)
2. \(Kl\)
3. \(\frac{Kl^2}{2}\)
4. \(Kl^2\)

When strain is produced in a body within elastic limit, its internal energy:
1. Remains constant                  
2. Decreases
3. Increases                               
4. None of the above

A wire is suspended by one end. At the other end a weight equivalent to 20 N force is applied. If the increase in length is 1.0 mm, the increase in energy of the wire will be

1. 0.01 J                               
2. 0.02 J
3. 0.04 J                               
4. 1.00 J

The ratio of Young's modulus of the material of two wires is 2 : 3. If the same stress is applied on both, then the ratio of elastic energy per unit volume will be-

1. 3 : 2                                   

2. 2 : 3

3. 3 : 4                                   

4. 4 : 3

The stress versus strain graphs for wires of two materials A and B are as shown in the figure. If $Y_A$ and $Y_B$ are the Young ‘s modulii of the materials, then

1. $Y_B=2Y_A$

2. $Y_A=Y_B$

3. $Y_B=3Y_A$

4. $Y_A=3Y_B$